Update Firmware on NEC SV8100 |  |
- Put firmware files onto root of clean USB drive
- Put the USB drive in to the SV8100
- Turn off system
- Press and hold small grey button to right of usb slot (labelled load sw)
- Whilst still holding grey button, power on system.
- Continue to hold grey button in.
- One of the red leds below the USB slot will start flashing
- Release grey button at this point
- After about 60 seconds THREE leds below usb will be flashing red
- Upgrade now complete
- Remove usb drive
- Reboot SV8100
- When it comes up, connect to PC Pro and near bottom of first screen on right side, check system software is at 9.5